Supplies
- Nike x Rit Shibori DIY Kit
- Plastic Table cover
- Fabric Pencil
- Container for Dyeing
- Salt
- Dish Soap
- Scissors
- Paper Towels
- Measuring spoons
- Rubber gloves
Time
Total: {{ partial.tQNW.total }}
Difficulty
Beginner Total: {{ partial.tRCL.total }}
Instructions
- Gather supplies.
- Prewash your cotton hoodie and leave it damp
- Trace circles randomly onto your damp hoodie using a small bowl and fabric pencil
- Pinch the center of each circle and gather the remainder so that the traced areas line up. Secure with rubber band.
- Starting at the rubber banded area, tightly wrap thread around the gathered fabric in a crisscross pattern and
- Remember that the pattern will vary based on the spacing and tension of the thread.
- Once hoodie is all bound, set aside and prepare the dyebath.
- Fill container with 3 gallons of hot water, ideally 140F or hotter.
- If tap water is not hot enough, heat water on the stove and carefully add it to the dyebath.
- Add 1 cup of salt and 1 tsp of dish soap.
- Pour 1/2 cup of well-shaken Rit All-Purpose Indigo Dye and stir.
- Test color by dipping a paper towel into the dyebath.
- If color is too light, add more dye. If color is too dark, add more water.
- Submerge bound hoodie and patches into dyebath.
- For a high contrast pattern, keep the bound hoodie in the dyebath for 5-10 minutes to keep the wrapped part dye-free. For more color and less white areas, keep the bound fabric in the dyebath for 10-20 minutes.
- Remove from dyebath and rinse hoodie in warm water then cool water until rinse water runs clear.
- Remove the rubber bands and thread bindings to reveal the kumo pattern.
- Wash in cold water and air dry.
Posts You May Like